PORTUGUÊS
ESPAÑOL

Index

Main Page

Download
Try a 30-day free copy!

Contact Form


Other products

International Databases

Punch-In Devices

Can be installed several punch-in devices on the same computer. Each computer on the network support up to one keyboard, um leitor óptico via teclado one barcode reader with keyboard interface and one barcode reader with serial interface (RS-232) for each serial port available.

Configure the Keyboard as a punch-in device:

1) Click on the Setup command
2) Click on the Add Device
3) Type "Keyboard" on the Device Name field
4) Complete the field Node (software licence #) with the number of the software licence for the PC where is connected the device. You don't need to do this if you are using the trial version
5) Select the Model "Generic"
6) Select the Connection "Keyboard"
7) Click on the Apply command
8) If you desire the employee to be required to type the 4-digits password after the digital key , select a value different that zero in the Time for password parameter.

Configure a Barcode Reader with Keyboard Interface as a punch-in device:

1) Plug in the barcode reader in the keyboard port
2) Plug in the keyboard in the "T" cable of the barcode reader
3) Click on the Setup command
4) Click on the Add Device command
5) Type a Device Name
6) Complete the field Node (software licence #) with the number of the software licence for the PC where is connected the device. You don't need to do this if you are using the trial version
7) Select the Model "Generic"
8) Select the Connection "Keyboard"
9) Click on the Apply command
10) If you desire the employee to be required to type the 4-digits password after the digital key , select a value different that zero in the Time for password parameter.
11) If you desire the employee to be required to pass a second time the badge to confirm the punch-in/out select a valuedifferent that zero in the Time for badge confirmation parameter

Configure a Barcode reader with serial RS-232 connection as a punch-in device:

1) Plug in the barcode reader in the serial port
2) Plug in the barcode reader power cord
3) Click on the Setup command
4) Click on the Add Device command
5) Type a Device Name
6) Complete the field Node (software licence #) with the number of the software licence for the PC where is connected the device. You don't need to do this if you are using the trial version
7) Select the barcode reader Model. If the model is not on the list select the "Generic" model
8) Select the serial port "COM1","COM2" or "COM3" in the Connection field. This port must to be the same where the device is connected.
9) In case your barcode reader model needs any special setup of the serial port, adjust the Baud Rate, Parity, Data Bits, and Stop Bits values depending on the device specifications.
10) Click on the Apply command
11) If you desire the employee to be required to type the 4-digits password after the digital key , select a value different that zero in the Time for password parameter.
12) If you desire the employee to be required to pass a second time the badge to confirm the punch-in/out select a valuedifferent that zero in the Time for badge confirmation parameter


To change a device configuration select the device on the list and click on the Setup Device command

To uninstall a device select the device on the list and click on theDelete Device command


Related pages:

Installing a barcode reader with RS-232 connection
Installing a biometric scanner (SecuGen)
Getting started ( Samples about setting up employee´s profiles and shifts )